Work Procedure
WARNING: This page is about a different car, the 2019 Infiniti QX60. However, it is still accessible from the selected car via links, so may be relevant.
- CHOOSE METHOD
There are three setting methods.
Which method do you choose?
With CONSULT
GO TO 2.
With set switch
GO TO 4.
- WITH CONSULT - STEP 1
Select "Work support".
GO TO 3.
- WITH CONSULT - STEP 2
- Select "EXIT SEAT SLIDE SETTING", or "EXIT TILT SETTING" then touch display to change between ON and OFF.
- EXIT SEAT SLIDE SETTING: Entry/exit assist (seat)
- EXIT TILT SETTING: Entry/exit assist (steering column)
- Select "SEAT SLIDE VOLUME SET" and touch either of "40 mm", "80 mm", or "150 mm".
- Then touch "OK".
Inspection End.
- Select "EXIT SEAT SLIDE SETTING", or "EXIT TILT SETTING" then touch display to change between ON and OFF.
- WITH SET SWITCH - STEP 1
Turn ignition switch OFF.
GO TO 5.
- WITH SET SWITCH - STEP 2
Push set switch and hold for more than 10 seconds, then confirm blinking of the memory switch indicator.
- Entry/exit assist (seat/steering column) are ON: Memory switch indicator blink two times.
- Entry/exit assist (seat/steering column) are OFF: Memory switch indicator blink once.
Inspection End.