DTC Confirmation Procedure

WARNING: This page is about a different car, the 2018 Nissan Maxima. However, it is still accessible from the selected car via links, so may be relevant.

CAUTION: Be careful of the driving speed.

PREPARATION BEFORE WORK
If another "DTC CONFIRMATION PROCEDURE" occurs just before, turn ignition switch OFF and wait for at least 10 seconds, then perform the next test.

GO TO STEP 2 .

CHECK DTC DETECTION 1

Start the engine.

Maintain the following conditions. (Keep 30 seconds or more after the selector lever shifted.)

Selector lever

: N - D, N - R, P - R

Check the first trip DTC.

Is "P2813" detected?

YES

Go to Diagnosis Procedure .

To check malfunction symptom before repair: Refer to Intermittent Incident .

Confirmation after repair: INSPECTION END