DTC Detection Logic

DTC

CONSULT screen terms

(Trouble diagnosis content)

DTC detection condition

P0965

PC SOLENOID B

(Pressure Control Solenoid B Control Circuit Range Performance)

1

Diagnosis condition

When all of the following conditions are satisfied:

• DTC other than the applicable DTC is not detected.
• Engine speed: More than 625 RPM
• Selector lever: Other than P/N position
• CVT fluid temperature: More than -20°C (-4°F)
• TCM power supply: More than 11 V
• The difference between instruction pressure of primary pressure and 10-msec-ago instruction primary pressure is 0 MPa or more
• Instruction pressure of primary pressure: 0.86 MPa or more
• Instruction pressure of primary pressure - primary pressure: More than 1.2 MPa

Signal

-

Threshold

When all of the following conditions are satisfied and this state is maintained for 1 second:

• DTC other than the applicable DTC is not detected.
• CVT fluid temperature: More than -20°C (-4°F)
• Selector lever: Other than P/N position
• Engine speed: More than 625 RPM
• Instruction pressure of primary pressure: More than 2 MPa
• Primary pressure: 0.4 MPa or less

Diagnosis delay time

Maintained for 10 seconds

2

Diagnosis condition

When all of the following conditions are satisfied:

• DTC other than the applicable DTC is not detected.
• CVT fluid temperature: More than -20°C (-4°F)
• Selector lever: Other than P/N position
• TCM power supply: More than 11 V
• The difference between instruction pressure of primary pressure and 10-msec-ago instruction primary pressure is 0 MPa or more
• Primary pressure - instruction pressure of primary pressure: More than 1.2 MPa

Signal

-

Threshold

When all of the following conditions are satisfied and this state is maintained for 5.5 seconds:

• DTC other than the applicable DTC is not detected.
• CVT fluid temperature: More than -20°C (-4°F)
• Selector lever: Other than P/N position
• Primary pressure - instruction pressure of primary pressure: 1.2 MPa or more

Diagnosis delay time

Maintained for 10 seconds