LEMON Manuals: Even more car manuals for everyone
Home >> Nissan-Datsun >> 2021 >> NV2500 HD S >> Repair and Diagnosis >> External Pages >> Different car >> Section 43 (Automatic Transaxle (DTC/Circuit Diagnosis)) >> DTC/Circuit Diagnosis >> DTC P0890: TCM >> DTC Confirmation Procedure

DTC Confirmation Procedure

WARNING: This page is about a different car, the 2018 Nissan Maxima. However, it is still accessible from the selected car via links, so may be relevant.
  1. PREPARATION BEFORE WORK 

    If another "DTC CONFIRMATION PROCEDURE" occurs just before, turn ignition switch OFF and wait for at least 10 seconds, then perform the next test.

    GO TO STEP 2  .

  2. CHECK DTC DETECTION 
    1. Start the engine and wait for 5 seconds or more.
    2. Check the DTC.

    Is "P0890" detected?

    YES

    Go to Diagnosis Procedure .

    NO

    To check malfunction symptom before repair: Refer to Intermittent Incident .

    NO

    Confirmation after repair: INSPECTION END

scientia non olet · About LEMON Manuals