DTC Detection Logic

WARNING: This page is about a different car, the 2018 Nissan Maxima. However, it is still accessible from the selected car via links, so may be relevant.

DTC	CONSULT screen terms (Trouble diagnosis content)	DTC detection condition
P0841	FLUID PRESS SEN/SW A (Transmission Fluid Pressure Sensor/Switch "A" Circuit Range/Performance)	Diagnosis condition	When all of the following conditions are satisfied: TCM power supply voltage: More than 11 V DTC other than the applicable DTC is not detected. Primary pulley speed: 300 RPM or more Secondary pulley speed: 250 RPM or more Target speed for shifting: Less than 0.1 seconds Pulley ratio: 0.5 - 1.0
		Signal	-
		Threshold	Primary pulley pressure is outside the specified value
		Diagnosis delay time	Maintained for 5 seconds