DTC Confirmation Procedure

WARNING: This page is about a different car, the 2018 Nissan Maxima. However, it is still accessible from the selected car via links, so may be relevant.

PREPARATION BEFORE WORK
If another "DTC CONFIRMATION PROCEDURE" occurs just before, turn ignition switch OFF and wait for at least 10 seconds, then perform the next test.

GO TO STEP 2 .
CHECK DTC DETECTION (PART 1)
With CONSULT
1. Start the engine.
2. Shift the selector lever to "D" position and wait for 1 second or more.
3. Select "Self Diagnostic Results" in "TRANSMISSION".
Is "P0826" detected?

YES

Go to Diagnosis Procedure .

NO

GO TO STEP 3 .
CHECK DTC DETECTION (PART 2)
With CONSULT
1. Shift the selector lever to manual shift gate and wait for 1 second or more.
2. Select "Self Diagnostic Results" in "TRANSMISSION".
Is "P0826" detected?

YES

Go to Diagnosis Procedure .

NO

GO TO STEP 4 .
CHECK DTC DETECTION (PART 3)
With CONSULT
1. Shift the selector lever to "UP" side (+ side) and wait for 1 second or more.
2. Select "Self Diagnostic Results" in "TRANSMISSION".
Is "P0826" detected?

YES

Go to Diagnosis Procedure .

NO

GO TO STEP 5 .
CHECK DTC DETECTION (PART 4)
With CONSULT
1. Shift the selector lever to "DOWN" side (- side) and wait for 1 second or more.
2. Select "Self Diagnostic Results" in "TRANSMISSION".
Is "P0826" detected?

YES

Go to Diagnosis Procedure .

NO

To check malfunction symptom before repair: Refer to Intermittent Incident .

NO

Confirmation after repair: INSPECTION END