DTC Detection Logic

DTC

CONSULT screen terms

(Trouble diagnosis content)

DTC detection condition

P0776

PC SOLENOID B

(Pressure Control Solenoid "B" Performance/Stuck Off)

1

Diagnosis condition

When all of the following conditions are satisfied:

• DTC other than the applicable DTC is not detected.
• Engine speed: More than 625 RPM
• Selector lever: Other than P/N position
• CVT fluid temperature: More than -20°C (-4°F)
• TCM power supply: More than 11 V
• The difference between instruction pressure of secondary pressure and 10-msec-ago instruction secondary pressure is 0 MPa or more
• Instruction pressure of secondary pressure: 0 MPa or more
• Instruction pressure of secondary pressure - secondary pressure: More than 1.2 MPa

Signal

-

Threshold

When all of the following conditions are satisfied and this state is maintained for 1.52 seconds:

• DTC other than the applicable DTC is not detected.
• CVT fluid temperature: More than -20°C (-4°F)
• Selector lever: Other than P/N position
• Instruction pressure of secondary pressure - secondary pressure: 0.25 MPa or more

Diagnosis delay time

Maintained for 10 seconds or more

2

Diagnosis condition

When all of the following conditions are satisfied:

• DTC other than the applicable DTC is not detected.
• CVT fluid temperature: More than -20°C (-4°F)
• Selector lever: Other than P/N position
• TCM power supply: More than 11 V
• The difference between instruction pressure of secondary pressure and 10-msec-ago instruction secondary pressure is 0 MPa or more
• Secondary pressure - instruction pressure of secondary pressure: More than 1.2 MPa

Signal

-

Threshold

When all of the following conditions are satisfied and this state is maintained for 5.5 seconds:

• DTC other than the applicable DTC is not detected.
• CVT fluid temperature: More than -20°C (-4°F)
• Selector lever: Other than P/N position
• Secondary pressure - instruction pressure of secondary pressure: 1.2 MPa or more

Diagnosis delay time

Maintained for 10 seconds or more