Removal and Installation: Removal
WARNING: This page is about a different car, the 2019 Infiniti QX60. However, it is still accessible from the selected car via links, so may be relevant.
- Remove front door finisher. Refer to Removal and Installation .
- Disconnect the harness connector from the power window and door lock/unlock switch (RH) (1).
- Remove two screws (A) and the power window and door lock/unlock switch RH (1) and finisher as an assembly.
- Release four pawls then separate power window and door lock/unlock switch (RH) (1) from switch finisher (2).
: Pawl