LEMON Manuals: Even more car manuals for everyone
Home >> Nissan-Datsun >> 2021 >> NV2500 HD S >> Repair and Diagnosis >> External Pages >> Different car >> Section 423 (Rear Suspension) >> Removal And Installation >> Rear Stabilizer >> Removal and Installation >> Removal

Removal and Installation: Removal

WARNING: This page is about a different car, the 2019 Infiniti QX60. However, it is still accessible from the selected car via links, so may be relevant.
  1. Apply matching marks to the rear suspension arms, the connecting rods, and the stabilizer shaft to identify the installation position.
  2. Remove the upper connecting rod nuts (A). Disconnect the connecting rods from the rear suspension arms.
    GNSDB114485Courtesy of NISSAN NORTH AMERICA, INC.
  3. Remove the stabilizer clamp bolts (A) using power tool.
    GNSDB112188Courtesy of NISSAN NORTH AMERICA, INC.
  4. Remove the stabilizer clamps.
  5. Remove the stabilizer bar bushings.
  6. Remove the stabilizer bar.
  7. Remove the lower connecting rod nuts. Disconnect the connecting rods from the stabilizer bar.
scientia non olet · About LEMON Manuals