LEMON Manuals: Even more car manuals for everyone
Home >> Nissan-Datsun >> 2021 >> NV2500 HD S >> Repair and Diagnosis >> External Pages >> Different car >> Section 423 (Rear Suspension) >> Removal And Installation >> Rear Lower Link Coil Spring >> Removal and Installation >> Removal

Removal and Installation: Removal

WARNING: This page is about a different car, the 2019 Infiniti QX60. However, it is still accessible from the selected car via links, so may be relevant.
  1. Remove the rear wheel and tire using power tool. Refer to Adjustment .
  2. Put alignment marks on the adjusting bolt and on the rear lower link.
    GNSLEIA09E-009Courtesy of NISSAN NORTH AMERICA, INC.
  3. Loosen the rear lower link adjusting bolt on the rear suspension member.
  4. Support the rear lower link with a suitable jack.
    WARNING: Place a suitable jack under the outer end of the rear lower link.
    CAUTION: Do not damage the rear lower link with the suitable jack.
  5. Support the rear knuckle with a suitable jack.
    WARNING: Place a suitable jack under the center of the rear knuckle.
    CAUTION: Do not damage the rear knuckle with the suitable jack.
  6. Remove the rear lower link nut and bolt from the rear knuckle using power tool.
  7. Slowly lower the suitable jack supporting the rear lower link. Remove the upper seat, the coil spring, and the lower seat from the rear lower link.
  8. Remove the rear lower link nut and bolt from the rear suspension member using power tool.
  9. Remove the rear lower link.
scientia non olet · About LEMON Manuals