LEMON Manuals: Even more car manuals for everyone
Home >> Nissan-Datsun >> 2021 >> NV2500 HD S >> Repair and Diagnosis >> External Pages >> Different car >> Section 418 (Front Suspension) >> Removal And Installation >> Front Stabilizer >> Removal and Installation >> Removal

Removal and Installation: Removal

WARNING: This page is about a different car, the 2019 Infiniti QX60. However, it is still accessible from the selected car via links, so may be relevant.
  1. Remove the wheels and tires using power tool. Refer to Adjustment .
  2. Remove heat insulator (AWD models).
  3. Remove rear propeller shaft (AWD models). Refer to Removal and Installation .
  4. Disconnect the LH outer socket from steering knuckle. Refer to Exploded View .
  5. Remove front exhaust tube. Refer to Exploded View .
  6. Remove engine rear mount bracket (FWD models).
  7. Disconnect steering column from steering gear. Refer to Exploded View .
  8. Remove the steering gear bolts. Refer to Exploded View .
  9. Position the steering gear forward.
  10. Disconnect the RH outer socket from steering knuckle. Refer to Exploded View .
  11. Remove stabilizer connecting rod nut (A) from front coil spring and strut.
    GNSALEIA0139Z-139Courtesy of NISSAN NORTH AMERICA, INC.
  12. Remove stabilizer connecting rod nut (A) from stabilizer bar and remove the stabilizer connecting rod.
    GNSALEIA0141Z-141Courtesy of NISSAN NORTH AMERICA, INC.
  13. Remove bolts (SYMBOL ) of stabilizer clamp, and then remove stabilizer clamp and stabilizer bushing from front suspension member.
    G04814021Courtesy of NISSAN NORTH AMERICA, INC.
  14. Remove stabilizer bar from the LH side of vehicle.
scientia non olet · About LEMON Manuals