LEMON Manuals: Even more car manuals for everyone
Home >> Nissan-Datsun >> 2021 >> NV2500 HD S >> Repair and Diagnosis >> External Pages >> Different car >> Section 417 (Wiper & Washer System) >> Removal And Installation >> Washer Tank >> Removal and Installation >> Removal

Removal and Installation: Removal

WARNING: This page is about a different car, the 2019 Infiniti QX60. However, it is still accessible from the selected car via links, so may be relevant.
  1. Fully open the hood.
  2. Remove the washer tank inlet clip (A) from the coolant reservoir and pull the washer tank inlet tube (1) from the washer tank.
    GNSALLIA1096Z-096Courtesy of NISSAN NORTH AMERICA, INC.
  3. Remove the front fender protector (RH). Refer to Removal and Installation .
  4. Disconnect the harness connector from the washer pump.
  5. Disconnect the harness connector from the washer level switch.
  6. Disconnect the front washer tube and rear washer tube.
  7. Remove the washer tank bolts.
  8. Remove the washer tank.
scientia non olet · About LEMON Manuals