Diagnosis Procedure

WARNING: This page is about a different car, the 2019 Infiniti QX60. However, it is still accessible from the selected car via links, so may be relevant.

CHECK DAYTIME RUNNING LIGHT RELAY VOLTAGE SUPPLY

Turn the ignition switch OFF.
Disconnect the daytime running light relay harness connector E4.
Turn the ignition switch ON.

Check the voltage between the following daytime running light relay harness connector E4 terminals and ground.

(+)		(-)	Voltage
Connector	Terminal
E4	2	Ground	Battery voltage
	5
	7

Is the inspection results normal?

YES

GO TO 3.

GO TO 2.

CHECK DAYTIME RUNNING LIGHT RELAY CIRCUIT

Turn the ignition switch OFF.
Disconnect IPDM E/R harness connector E121.

Check continuity between the IPDM E/R harness connector E121 and the daytime running light relay harness connector E4.

Daytime running light relay		IPDM E/R		Continuity
Connector	Terminal	Connector	Terminal
E4	2	E121	14	Yes
	5
	7

Check continuity between the IPDM E/R harness connector E121 and ground.

Connector		Terminal	(--)	Continuity
E121		14	Ground	No

Is the inspection results normal?

YES

Replace IPDM E/R. Refer to Removal and Installation .

Repair or replace the harnesses or connectors.

CHECK DAYTIME RUNNING LAMP RELAY COIL CIRCUIT

Check continuity between the IPDM E/R harness connector E218 and daytime running light relay harness connector E4.

IPDM E/R		Daytime running light relay		Continuity
Connector	Terminal	Connector	Terminal
E218	85	E4	1	Yes

Check continuity between the IPDM E/R harness connector E218 and ground.

Connector		Terminal	Ground	Continuity
E218		85		No

Is the inspection results normal?

YES

GO TO 4.

Repair or replace the harnesses or connectors.

CHECK DAYTIME RUNNING LIGHT RELAY
Check the daytime running light relay. Refer to Component Inspection .

Is the inspection results normal?

YES

GO TO 5.

NO

Replace relay.

CHECK DAYTIME RUNNING LAMP CIRCUIT FOR OPEN

Turn the ignition switch OFF.
Disconnect the front combination lamp harness connector E233 or E238 in question.

Check continuity between the daytime running light relay harness connector E4 and the front combination lamp harness connector E233 or E238.

Front combination lamp		Daytime running light relay		Continuity
Connector	Terminal	Connector	Terminal
LH E233	7	E4	6	Yes
RH E238			3

Is the inspection results normal?

YES

GO TO 6.

Repair or replace the harnesses or connectors.

CHECK DAYTIME RUNNING LAMP GROUND CIRCUIT FOR OPEN

Turn the ignition switch OFF.
Disconnect front combination lamp harness connector E233 or E238 in question.

Check continuity between the front combination lamp harness connector E233 or E238 terminal 3 and ground.

Connector	Terminal	(-)	Continuity
LH E233	3	Ground	Yes
RH E238

Does continuity exist?

YES

Inspection End.

Repair or replace the harnesses or connectors.