Component Inspection
WARNING: This page is about a different car, the 2019 Infiniti QX60. However, it is still accessible from the selected car via links, so may be relevant.
- CHECK SWITCH
- Turn ignition switch OFF.
- Disconnect back door lock assembly connector.
- Check continuity between back door lock assembly terminals.
Back door lock assembly
Condition
Continuity
Terminal
4
8
Back door lock
Open
Yes
Fully closed/Half latch
No
5
Fully close
Yes
Open/Half latch
No
6
Half latch
Yes
Fully closed/Open
No
7
Back door switch
On
Yes
Off
No
Is the inspection result normal?
YES
Inspection End.
NO
Replace back door lock assembly. Refer to Removal and Installation .