Component Inspection

WARNING: This page is about a different car, the 2019 Infiniti QX60. However, it is still accessible from the selected car via links, so may be relevant.

CHECK SWITCH

Turn ignition switch OFF.
Disconnect back door lock assembly connector.

Check continuity between back door lock assembly terminals.

Back door lock assembly		Condition		Continuity
Terminal
4	8	Back door lock	Open	Yes
			Fully closed/Half latch	No
5			Fully close	Yes
			Open/Half latch	No
6			Half latch	Yes
			Fully closed/Open	No
7		Back door switch	On	Yes
			Off	No

Is the inspection result normal?

YES

Inspection End.

Replace back door lock assembly. Refer to Removal and Installation .