LEMON Manuals: Even more car manuals for everyone
Home >> Nissan-Datsun >> 2021 >> NV2500 HD S >> Repair and Diagnosis >> External Pages >> Different car >> Section 40 (Cruise Control System (DTC/Circuit Diagnosis)) >> DTC / Circuit Diagnosis >> DTC C1A24: NP Range >> DTC Confirmation Procedure

DTC Confirmation Procedure

WARNING: This page is about a different car, the 2018 Nissan Maxima. However, it is still accessible from the selected car via links, so may be relevant.
  1. CHECK DTC PRIORITY 

    If DTC "C1A24" is displayed with DTC "U1000", first diagnose the DTC "U1000".

    Is applicable DTC detected?

    YES

    Perform diagnosis of applicable DTC. Refer to DTC Logic .

    NO

    GO TO 2.

  2. CHECK DTC (1) 

    SYMBOL CONSULT

    1. Start the engine.
    2. Turn the MAIN switch of ICC system ON.
    3. Wait for approximately 5 minutes or more after shifting the selector lever to "P" position.
    4. Select "Self Diagnostic Result" mode of "LASER/RADAR".
    5. Check if the "C1A24" is detected as the current malfunction in "Self Diagnostic Result" mode of "LASER/RADAR".

    Is "C1A24" detected as the current malfunction?

    YES

    Refer to Diagnosis Procedure .

    NO

    GO TO 3

  3. CHECK DTC (2) 

    SYMBOL CONSULT

    1. Wait for approximately 5 minutes or more after shifting the selector lever to "N" position.
    2. "Self Diagnostic Result" mode of "ICC/ADAS".
    3. Check if the "C1A24" is detected as the current malfunction in "Self Diagnostic Result" mode of "ICC/ADAS".

    Is "C1A24" detected as the current malfunction?

    YES

    Refer to Diagnosis Procedure .

    NO

    To check malfunction symptom before repair: Refer to Intermittent Incident .

    NO

    Confirmation after repair: Inspection End.

scientia non olet · About LEMON Manuals