Work Procedure (After Replacement)

WARNING: This page is about a different car, the 2019 Infiniti QX60. However, it is still accessible from the selected car via links, so may be relevant.

CAUTION:

Use "Manual Configuration" only when "Type ID" of CAN gateway cannot be read.
If an error occurs during configuration, start over from the beginning.

CHECKING AIR PRESSURE MONITOR TYPE ID
Check if "Type ID" of air pressure monitor is saved on CONSULT.

Is "TYPE ID" saved on CONSULT?

YES

GO TO 2.

NO

GO TO 3.
WRITING TYPE ID OF AIR PRESSURE MONITOR (AUTOMATIC WRITING)
CONSULT Configuration
1. Select "After Replace ECU" of "Re/programming, Configuration" or that of "Read / Write Configuration".
2. Compare "Type ID" displayed on the CONSULT screen with BCM "Type ID" searched for by using FAST (service parts catalogue), and write matching "Type ID" on BCM.
  NOTE: For the "Type ID" searched by using FAST (service parts catalog), use the last five digits of the "Type ID".
GO TO 4.
WRITING TYPE ID OF AIR PRESSURE MONITOR (MANUAL WRITING)
CONSULT Configuration
1. Select "Manual Configuration".
2. Select "Type ID" searched for by using FAST (service parts catalogue) and write the ID on BCM.
  NOTE: For the "Type ID" searched by using FAST (service parts catalog), use the last five digits of the "Type ID".
GO TO 4.
CHECKING AIR PRESSURE MONITOR TYPE ID AND BCM TYPE ID
Compare the air pressure monitor "Type ID" displayed on the CONSULT screen with BCM "Type ID" searched for by using FAST (service parts catalogue), and check that these IDs match.

NOTE: For the "Type ID" searched by using FAST (service parts catalog), use the last five digits of the "Type ID".

GO TO 5.
PERFORM TIRE PRESSURE SENSOR ID REGISTRATION
Perform the tire pressure sensor ID registration. Refer to Description .

GO TO 6.
PERFORM SUPPLEMENTARY WORK
1. Perform the tire air pressure. Refer to Tire Air Pressure .
2. Perform the self-diagnosis of all systems.
3. Erase self-diagnosis results.
End of work.