Diagnosis Procedure

WARNING: This page is about a different car, the 2018 Nissan Maxima. However, it is still accessible from the selected car via links, so may be relevant.

MAIN switch does not turn ON

ICC system display does not appear even when MAIN switch is pressed.

MAIN switch does not turn OFF

When ICC system display is ON, display does not turn OFF even if MAIN switch is pressed.

NOTE: When ICC system warning lamp illuminates, perform the self-diagnosis of ICC system, and then repair or replace the malfunctioning parts.

MAIN SWITCH INSPECTION
CONSULT
1. Start the engine.
2. Check that "MAIN SW" and "CRUISE LAMP" operate normally in "Data Monitor" mode of "ICC/ADAS".
Is the inspection result normal?

YES

GO TO 2

NO

GO TO 4
CHECK COMBINATION METER
CONSULT

Check that "CRUISE IND" operates normally in "Data Monitor" mode of "METER/M&A".

Is the inspection result normal?

YES

GO TO 3

NO

GO TO 4
PERFORM SELF DIAGNOSTIC RESULT OF COMBINATION METER
CONSULT
1. Select "Self Diagnostic Result" mode of "METER/M&A".
2. Check if DTC is detected. Refer to DTC Index .
Is any DTC detected?

YES

Repair or replace malfunctioning parts.

NO

GO TO 4
PERFORM SELF DIAGNOSTIC RESULT OF ICC SYSTEM
CONSULT
1. Select "Self Diagnostic Result" mode of "ICC/ADAS".
2. Check if DTC "U1000" is detected in.
Is "U1000" detected?

YES

GO TO 5

NO

GO TO 6
CAN COMMUNICATION INSPECTION
Check the CAN communication and repair or replace malfunctioning parts. Refer to System Description .

Inspection End.
CHECK ICC STEERING SWITCH
Check the ICC steering switch. Refer to Component Inspection .

Inspection End.