Removal and Installation: Installation
WARNING: This page is about a different car, the 2019 Infiniti QX60. However, it is still accessible from the selected car via links, so may be relevant.
- Finger tighten bolts.
- Tighten bolts to specification in sequence show.
Bolts (1, 2)
: 55.0 N.m (5.6 kg-m, 41.0 fl-lb)
Bolts (3, 4)
: 61.3 N.m (6.3 kg-m, 45.0 fl-lb)
- Connect the harness connector to the compressor.
- Connect the high-pressure flexible hose to the compressor.CAUTION:
- Do not reuse O-rings.
- Apply A/C oil to new O-rings for installation.
- Connect the low-pressure flexible hose to the compressor.CAUTION:
- Do not reuse O-rings.
- Apply A/C oil to new O-rings for installation.
- Install the drive belt. Refer to DRIVE BELT
.CAUTION: Check the tension of the drive belt after installing the compressor. Refer to DRIVE BELT .
- Install the bolts that retain the oil cooler line brackets to the engine block. Refer to Removal and Installation .
- Install the front fender protector (RH). Refer to Removal and Installation .
- Recharge the refrigerant. Refer to Charge Refrigerant .CAUTION: After charging refrigerant, check for leaks. Refer to Leak Test .