Removal and Installation: Removal
WARNING: This page is about a different car, the 2019 Infiniti QX60. However, it is still accessible from the selected car via links, so may be relevant.
CAUTION:
Do not apply tack-paper adhesive remover to body panel surface finished with lacquer-based paints.
- Original side guard molding is affixed to body panel with double-faced adhesive tape.
- Heat molding to between 30 deg. - 40 deg.C (86 deg. - 104 deg.F) with a heat gun.
- Raise end of molding to release clips, then cut away tape to remove molding. Remove all traces of tape.