Diagnosis Procedure

WARNING: This page is about a different car, the 2018 Nissan Maxima. However, it is still accessible from the selected car via links, so may be relevant.

CHECK CONTINUITY OF REAR VIEW CAMERA POWER SUPPLY AND GROUND CIRCUIT

Turn ignition switch OFF.
Disconnect around view monitor control unit connector M170 and rear view camera connector B76.

Check continuity between around view monitor control unit connector M170 and rear view camera connector B76.

Around view monitor control unit		Rear view camera		Continuity
Connector	Terminal	Connector	Terminal
M170	17	B76	1	Yes
	18		2

Check continuity between around view monitor control unit connector M170 and ground.

Around view monitor control unit		Ground	Continuity
Connector	Terminal
M170	18		No

Is the inspection result normal?

YES

GO TO 2 .

Repair harness or connector.

CHECK VOLTAGE OF REAR VIEW CAMERA POWER SUPPLY

Connect around view monitor control unit connector M170 and rear view camera connector B76.
Turn ignition switch ON.

Check voltage between around view monitor control unit connector M170 and ground.

(+)		(-)	Condition	Voltage (Approx.)
Around view monitor control unit
Connector	Terminal
M170	18	Ground	"CAMERA" switch is ON or shift position is "R".	6.0 V

Is the inspection result normal?

YES

GO TO 3 .

Replace around view monitor control unit. Refer to Removal and Installation .

CHECK CONTINUITY OF REAR VIEW CAMERA IMAGE SIGNAL CIRCUIT

Turn ignition switch OFF.
Disconnect around view monitor control unit connector M170 and rear view camera connector B76.

Check continuity between around view monitor control unit connector M170 and rear view camera connector B76.

Around view monitor control unit		Rear view camera		Continuity
Connector	Terminal	Connector	Terminal
M170	19	B76	5	Yes
	20		4

Check continuity between around view monitor control unit harness connector M170 and ground.

Around view monitor control unit		Ground	Continuity
Connector	Terminal
M170	20		No

Is the inspection result normal?

YES

GO TO 4 .

Repair harness or connector.

CHECK REAR VIEW CAMERA IMAGE SIGNAL

Connect around view monitor control unit connector M170 and rear view camera connector B76.
Turn ignition switch ON.

Check signal between around view monitor control unit connector M170.

Around view monitor control unit			Condition	Reference value
Connector	(+)	(-)
	Terminal
M170	20	19	"CAMERA" switch is ON or shift position is "R".	Courtesy of NISSAN NORTH AMERICA, INC.

Is the inspection result normal?

YES

Replace around view monitor control unit. Refer to Removal and Installation .

Replace rear view camera. Refer to Removal and Installation .