LEMON Manuals: Even more car manuals for everyone
Home >> Nissan-Datsun >> 2021 >> NV2500 HD S >> Repair and Diagnosis >> External Pages >> Different car >> Section 374 (Engine Cooling System) >> Removal And Installation >> Radiator >> Removal and Installation >> Removal

Removal and Installation: Removal

WARNING: This page is about a different car, the 2019 Infiniti QX60. However, it is still accessible from the selected car via links, so may be relevant.
  1. Disconnect negative battery terminal. Refer to Removal and Installation .
  2. Drain engine coolant from radiator. Refer to Changing Engine Coolant .
    CAUTION:
    • Perform this step when the engine is cold.
    • Do not spill engine coolant on the drive belt.
  3. Partially remove front fender protector. Refer to Removal and Installation .
  4. Remove front under cover. Refer to Removal and Installation .
  5. Remove front bumper fascia. Refer to Removal and Installation .
  6. Disconnect reservoir tank hose from radiator.
  7. Disconnect radiator hose (upper) and radiator hose (lower) from the radiator.
    CAUTION: Do not allow the engine coolant to contact the drive belt.
    NOTE: The radiator hose clamps on the radiator hose (upper) and on the radiator hose (lower), are not serviced separately. Radiator hose clamps are part of the radiator hose assembly and serviced as one unit with the radiator hose.
  8. Disconnect the CVT fluid cooler hoses.
  9. Remove A/C condenser. Refer to Removal and Installation .
  10. Remove the radiator mounts (upper).
  11. Remove radiator.
    CAUTION: Do not damage or scratch the radiator core when removing.
scientia non olet · About LEMON Manuals