LEMON Manuals: Even more car manuals for everyone
Home >> Nissan-Datsun >> 2021 >> NV2500 HD S >> Repair and Diagnosis >> External Pages >> Different car >> Section 373 (Engine Lubrication System) >> Removal And Installation >> Oil Pump >> Removal and Installation >> Removal

Removal and Installation: Removal

WARNING: This page is about a different car, the 2019 Infiniti QX60. However, it is still accessible from the selected car via links, so may be relevant.
  1. Remove the oil pan (lower). Refer to Removal and Installation (Lower Oil Pan) .
  2. Loosen bolts (B) and remove engine oil pressure control solenoid valve (2).
    GNSALBIA3208Z-208Courtesy of NISSAN NORTH AMERICA, INC.
    CAUTION: Do not reuse O-rings.
  3. Remove bolt (A) and remove oil pump drive chain cover (1).
  4. Rotate oil pump drive chain tensioner (1) counterclockwise with a suitable tool and remove oil pump drive chain (2) from oil pump gear.
    GNSALBIA3207Z-207Courtesy of NISSAN NORTH AMERICA, INC.
  5. Loosen the oil pump bolts (A) in reverse of the sequence shown and remove.
    GNSALBIA3221Z-221Courtesy of NISSAN NORTH AMERICA, INC.
    CAUTION: Do not reuse O-rings.
  6. Remove the O-rings (1) from the bottom of the cylinder block and oil pump housing.
    CAUTION: Do not reuse O-ring.
scientia non olet · About LEMON Manuals