Diagnosis Procedure

WARNING: This page is about a different car, the 2018 Nissan Maxima. However, it is still accessible from the selected car via links, so may be relevant.

The Easy Fill Tire Alert does not function while inflating a tire when the select lever position is in P-range with the ignition switch ON.

NOTE:

After starting to inflate the tire, it takes a few seconds for the Easy Fill Tire Alert to function.
If there is no response for approximately 15 seconds or more after inflating the tires, cancel the use of the Easy Fill Tire Alert function or move the vehicle approximately 1 m (3.2 ft.) backward or forward to try again. The air filler pressure may be weak or out of service area.
For Easy Fill Tire Alert, Refer to Easy Fill Tire Alert Function .

LOCATION CHANGE
Move the vehicle to another area and repeat the procedure of the Easy Fill Tire Alert function. Refer to Easy Fill Tire Alert Function .

Is the function normal?

YES

Inspection End.

NO

GO TO STEP 2 .
PERFORM SELF DIAGNOSTIC RESULT
With CONSULT
1. Turn ignition switch ON.
2. Select "Self Diagnostic Result" mode in "AIR PRESSURE MONITOR" of "BCM".
3. Check DTC.
Are any DTCs detected?

YES

Refer to DTC Index .

NO

GO TO STEP 3 .
CHECK HAZARD WARNING LAMP OPERATION
Check hazard warning lamp operation with hazard switch.

Do the hazard warning lamps operate?

YES

GO TO STEP 4 .

NO

Refer to Diagnosis Procedure .
PERFORM SELF DIAGNOSTIC RESULT FOR TCM
With CONSULT
1. Turn ignition switch ON.
2. Select "Self Diagnostic Result" mode of "TRANSMISSION".
3. Check DTC.
Are any DTCs detected?

YES

Refer to CONSULT Function .

NO

GO TO STEP 5 .
CHECK HORN OPERATION
Check horn operation. Refer to Diagnosis Procedure .

Is the inspection result normal?

YES

GO TO STEP 6 .

NO

Repair or replace malfunctioning components.
PERFORM SELF DIAGNOSTIC RESULT
With CONSULT
1. Drive at a speed of 40 km/h (25 MPH) or more for 3 minutes, and then drive the vehicle at any speed for 10 minutes.
2. Select "Self Diagnostic Result" mode in "AIR PRESSURE MONITOR" of "BCM".
3. Check DTC.
Are any DTCs detected?

YES

Refer to DTC Index .

NO

Replace BCM. Refer to Removal and Installation .