Diagnosis Procedure

1. Turn the ignition switch OFF.
2. Disconnect parking brake switch harness connector.
3. Disconnect combination meter harness connector.
4. Check the continuity between parking brake switch harness connector and combination meter harness connector.

   Parking brake switch		Combination meter		Continuity
   Connector	Terminal	Connector	Terminal
   E35	1	M24	26	Yes

5. Check the continuity between parking brake switch harness connector and ground.

   Parking brake switch		-	Continuity
   Connector	Terminal
   E35	1	Ground	No

Is the inspection result normal?

YES

GO TO 2 .

NO

Repair or replace error-detected parts.

Check the parking brake switch. Refer to Inspection .

Is the inspection result normal?

YES

GO TO 3 .

NO

Replace the parking brake switch. Refer to Removal and Installation .

CONSULT

1. Select "Data Monitor" mode of "ICC/ADAS".
2. Select "PKB SW".
3. Check that the function operates normally according to the following conditions:

   Condition	Data Monitor
   Operate parking brake.	On
   Release parking brake.	Off

Is the inspection result normal?

YES

Inspection End.

NO

GO TO 4 .

Check the combination meter. Refer to CONSULT Function (METER/M&A) .

Is the inspection result normal?

YES

GO TO 5 .

NO

Repair or replace combination meter. Refer to Removal and Installation .

1. Check the combination meter pin terminals for damage or loose connection with harness connector.
2. Check the parking brake switch pin terminals for damage or loose connection with harness connector.

Is the inspection result normal?

YES

Replace the ABS actuator and electric unit (control unit). Refer to Removal and Installation .

NO

Repair or replace error-detected parts.