LEMON Manuals: Even more car manuals for everyone
Home >> Nissan-Datsun >> 2021 >> NV2500 HD S >> Repair and Diagnosis >> External Pages >> Different car >> Section 36 (Brake Control System (W/ Intelligent Cruise Control) (2 Of 2)) >> DTC/Circuit Diagnosis >> C1160 Incomplete DECEL G Sensor Calibration >> Diagnosis Procedure

Diagnosis Procedure

WARNING: This page is about a different car, the 2018 Nissan Maxima. However, it is still accessible from the selected car via links, so may be relevant.
  1. CALIBRATION OF DECEL G SENSOR 

    Perform calibration of decel G sensor. Refer to Work Procedure .

    GO TO 2 .

  2. CHECK ABS ACTUATOR AND ELECTRIC UNIT (CONTROL UNIT) 

    SYMBOL CONSULT

    1. Turn the ignition switch OFF.
      NOTE: Wait at least 10 seconds after turning ignition switch OFF.
    2. Start the engine.
      NOTE: Wait at least 10 seconds after starting the engine.
    3. Perform "Self Diagnostic Result" mode of "ABS".

    Is DTC "C1160" detected?

    YES

    Replace the ABS actuator and electric unit (control unit). Refer to Removal and Installation .

    NO

    Inspection End.

scientia non olet · About LEMON Manuals