LEMON Manuals: Even more car manuals for everyone
Home >> Nissan-Datsun >> 2021 >> NV2500 HD S >> Repair and Diagnosis >> External Pages >> Different car >> Section 36 (Brake Control System (W/ Intelligent Cruise Control) (2 Of 2)) >> DTC/Circuit Diagnosis >> C1154 Transmission Range Switch >> Diagnosis Procedure

Diagnosis Procedure

WARNING: This page is about a different car, the 2018 Nissan Maxima. However, it is still accessible from the selected car via links, so may be relevant.
CAUTION: "C1154" may be detected when going up a slope, being towed with ignition switch ON and the shift selector in a position other than R position. This is not a shift position error. The system returns to normal once the vehicle is stopped, parked on level ground and the engine is started.
  1. CHECK CVT SYSTEM 

    SYMBOL CONSULT

    Select "Self Diagnostic Result" mode of "TRANSMISSION".

    Is DTC detected?

    YES

    Check the DTC. Refer to DTC Index (RE0F10H).

    NO

    GO TO 2 .

  2. PERFORM SELF-DIAGNOSIS 

    SYMBOL CONSULT

    1. Erase "Self Diagnostic Result" mode of "ABS".
    2. Turn the ignition switch OFF.
      NOTE: Wait at least 10 seconds after turning ignition switch OFF.
    3. Start the engine.
      NOTE: Wait at least 10 seconds after starting the engine.
    4. Drive the vehicle for a short period of time.
      NOTE: Vehicle must be driven after repair or replacement to erase the previous DTCs.
    5. Stop the vehicle.
    6. Select "Self Diagnostic Result" mode of "ABS".

    Is DTC "C1154" detected?

    YES

    Replace the ABS actuator and electric unit (control unit). Refer to Removal and Installation .

    NO

    Check pin terminals and connection of each harness connector for abnormal conditions. Repair / replace harness, connector, or terminal.

scientia non olet · About LEMON Manuals