Diagnosis Procedure
WARNING: This page is about a different car, the 2018 Nissan Maxima. However, it is still accessible from the selected car via links, so may be relevant.
- CHECK ABS ACTUATOR AND ELECTRIC UNIT (CONTROL UNIT) POWER SUPPLY AND GROUND CIRCUIT
Perform the trouble diagnosis for ABS actuator and electric unit (control unit) power supply and ground circuit. Refer to Diagnosis Procedure .
Is the inspection result normal?
YES
GO TO 2 .
NO
Repair or replace error-detected parts.
- PERFORM THE SELF DIAGNOSTIC RESULT
CONSULT
- Turn the ignition switch OFF → ON.CAUTION:
- Be sure to wait 10 seconds after turning ignition switch OFF or ON.
- Start the engine.
- Repeat step 1 two or more times.
- Perform "Self Diagnostic Result" mode of "ABS".
Is any DTC detected?
YES
Check the DTC. Refer to DTC Index .
NO
GO TO 3 .
- Turn the ignition switch OFF → ON.
- CHECK BRAKE WARNING LAMP SIGNAL
- Select "ABS", "Data Monitor" and "EBD WARN LAMP" in this order.
- Turn the ignition switch OFF.
- Check that "Data Monitor" displays "On" for 1 second after ignition switch is turned ON and then changes to "Off".CAUTION: Never start the engine.
Is the inspection result normal?
YES
Replace the combination meter. Refer to Removal and Installation .
NO
Replace the ABS actuator and electric unit (control unit). Refer to Removal and Installation .