Diagnosis Procedure
WARNING: This page is about a different car, the 2019 Infiniti QX60. However, it is still accessible from the selected car via links, so may be relevant.
- CHECK VIAS CONTROL SOLENOID VALVE 1 POWER SUPPLY
- Turn ignition switch OFF.
- Disconnect VIAS control solenoid valve 1 harness connector.
- Turn ignition switch ON.
- Check the voltage between VIAS control solenoid valve 1 harness connector and ground.
+
-
Voltage
VIAS control solenoid valve 1
Connector
Terminal
F66
1
Ground
Battery voltage
Is the inspection result normal?
YES
GO TO 3.
NO
GO TO 2.
- CHECK VIAS CONTROL SOLENOID VALVE 1 POWER SUPPLY CIRCUIT
- Turn ignition switch OFF.
- Disconnect IPDM E/R harness connector.
- Check the continuity between VIAS control solenoid valve 1 harness connector and IPDM E/R harness connector.
VIAS control solenoid valve 1
IPDM E/R
Continuity
Connector
Terminal
Connector
Terminal
F66
1
E121
13
Existed
- Also check harness for short to ground.
Is the inspection result normal?
YES
Perform the trouble diagnosis for power supply circuit.
NO
Repair or replace error-detected parts.
- CHECK VIAS CONTROL SOLENOID VALVE 1 OUTPUT SIGNAL CIRCUIT
- Turn ignition switch OFF.
- Disconnect ECM harness connector.
- Check the continuity between VIAS control solenoid valve 1 harness connector and ECM harness connector.
VIAS control solenoid valve 1
ECM
Continuity
Connector
Terminal
Connector
Terminal
F66
2
F79
136
Existed
- Also check harness for short to ground and short to power.
Is the inspection result normal?
YES
GO TO 4.
NO
Repair or replace error-detected parts.
- CHECK VIAS CONTROL SOLENOID VALVE 1
Check VIAS control solenoid valve 1. Refer to Component Inspection .
Is the inspection result normal?
YES
INSPECTION END
NO
Replace VIAS control solenoid valve 1. Refer to VALVE TIMING CONTROL .