Component Inspection

WARNING: This page is about a different car, the 2019 Infiniti QX60. However, it is still accessible from the selected car via links, so may be relevant.

CHECK ASCD STEERING SWITCH

Turn ignition switch OFF.
Disconnect combination switch (spiral cable) harness connector M149.

Check resistance between combination switch harness connector terminals under the following conditions.

Combination switch			Condition	Resistance (Approx.)
Connector	Terminals
M149	13	16	MAIN switch: Pressed	0 Ohm
			CANCEL switch: Pressed	250 Ohm
			COAST/SET switch: Pressed	660 Ohm
			ACCEL/RES switch: Pressed	1, 480 Ohm
			All ASCD steering switches: Released	4, 000 Ohm

Is the inspection result normal?

YES

INSPECTION END

Replace ASCD steering switch. Refer to Removal and Installation .