Component Inspection (Accelerator Pedal Position Sensor)

WARNING: This page is about a different car, the 2019 Infiniti QX60. However, it is still accessible from the selected car via links, so may be relevant.

CHECK ACCELERATOR PEDAL POSITION SENSOR

Turn ignition switch OFF.
Reconnect all harness connectors disconnected.
Turn ignition switch ON.

Check the voltage ECM harness connector terminals as per the following.

ECM			Condition		Voltage
Connector	+	-
	Terminal
E32	202 (APP sensor 1)	203	Accelerator pedal	Fully released	0.45 - 1.0 V
				Fully depressed	4.4 - 4.8 V
	195 (APP sensor 2)	196		Fully released	0.22 - 0.50 V
				Fully depressed	2.1 - 2.5 V

Is the inspection result normal?

YES

INSPECTION END

Replace accelerator pedal assembly. Refer to Removal and Installation (models without distance control assist system), Removal and Installation (models with distance control assist system).