DTC Detection Logic
WARNING: This page is about a different car, the 2019 Infiniti QX60. However, it is still accessible from the selected car via links, so may be relevant.
|
DTC
|
CONSULT screen terms
(Trouble diagnosis content)
|
DTC detection condition
|
Possible causes
|
|
P0965
|
PC SOLENOID B
(Pressure Control Solenoid B Control Circuit Range Performance)
|
When any of 1 or 2 is satisfied and this state is maintained for 10 seconds:
- When all of the following conditions are satisfied:
- DTC other than the applicable DTC is not detected.
- Engine speed: More than 625 RPM
- Selector lever: Other than P/N position
- CVT fluid temperature: More than -20 deg.C (-4 deg.F)
- TCM power supply: More than 11 V
- The difference between instruction pressure of primary pressure and 10-msec-ago instruction primary pressure is 0 MPa or more
- Instruction pressure of primary pressure: 0.86 MPa or more
- Instruction pressure of primary pressure - primary pressure: More than 1.2 MPa
- When all of the following conditions are satisfied and this state is maintained for 1 second:
- DTC other than the applicable DTC is not detected.
- CVT fluid temperature: More than -20 deg.C (-4 deg.F)
- Selector lever: Other than P/N position
- Engine speed: More than 625 RPM
- Instruction pressure of primary pressure: More than 2 MPa
- Primary pressure: 0.4 MPa or less
- When all of the following conditions are satisfied:
- DTC other than the applicable DTC is not detected.
- CVT fluid temperature: More than -20 deg.C (-4 deg.F)
- Selector lever: Other than P/N position
- TCM power supply: More than 11 V
- When all of the following conditions are satisfied and this state is maintained for 5.5 seconds:
- DTC other than the applicable DTC is not detected.
- CVT fluid temperature: More than -20 deg.C (-4 deg.F)
- Selector lever: Other than P/N position
- Primary pressure - instruction pressure of primary pressure: 1.2 MPa or more
- The difference between instruction pressure of primary pressure and 10-msec-ago instruction primary pressure is 0 MPa or more
- Primary pressure - instruction pressure of primary pressure: More than 1.2 MPa
|
|