DTC Confirmation Procedure

WARNING: This page is about a different car, the 2019 Infiniti QX60. However, it is still accessible from the selected car via links, so may be relevant.

CAUTION: Be careful of the driving speed.

PREPARATION BEFORE WORK
If another "DTC CONFIRMATION PROCEDURE" occurs just before, turn ignition switch OFF and wait for at least 10 seconds, then perform the next test.

GO TO 2.

PREPARATION BEFORE OPERATION

With CONSULT

Start the engine.
Select "Data Monitor" in "TRANSMISSION".
Select "FLUID TEMP".

Confirm that the CVT fluid temperature is in the following range.

FLUID TEMP

: 20 deg.C (68 deg.F) or more

With GST

Start the engine.
Set the CVT fluid to 20 deg.C (68 deg.F) or more.
NOTE: When the ambient temperature is 20 deg.C (68 deg.F), the CVT fluid usually increases to 50 to 80 deg.C (122 to 176 deg.F) with driving in an urban area for approximately 10 minutes.

Is the CVT fluid 20 deg.C (68 deg.F) or more?

YES

GO TO 3.

Warm the transaxle.
GO TO 3.

CHECK DTC DETECTION

Drive the vehicle.

Maintain the following conditions for 10 seconds or more.

Selector lever	: "D" position
Vehicle speed	: 40 km/h (25 MPH) or more

Stop the vehicle.
Check the first trip DTC.

Is "P0743" detected?

YES

Go to Diagnosis Procedure .

INSPECTION END