LEMON Manuals: Even more car manuals for everyone
Home >> Nissan-Datsun >> 2021 >> NV2500 HD S >> Repair and Diagnosis >> External Pages >> Different car >> Section 343 (Brake System) >> Removal And Installation >> Rear Disc Brake >> Brake Caliper Assembly >> Removal and Installation >> Removal

Removal and Installation: Removal

WARNING: This page is about a different car, the 2019 Infiniti QX60. However, it is still accessible from the selected car via links, so may be relevant.
  1. Remove rear wheels and tires using power tool. Refer to Adjustment .
  2. Secure the disc brake rotor using wheel nuts.
  3. Remove union bolt, copper sealing washers, and disconnect brake hose from brake caliper. Discard the copper sealing washers.
    CAUTION: Do not reuse copper sealing washers.
  4. Remove the torque member bolts. Remove the brake caliper and torque member from the vehicle as an assembly.
  5. Remove sliding pin bolts and the brake caliper from torque member.
    CAUTION: Do not drop brake pads or brake caliper.
scientia non olet · About LEMON Manuals