Removal and Installation: Installation
WARNING: This page is about a different car, the 2019 Infiniti QX60. However, it is still accessible from the selected car via links, so may be relevant.
- If necessary, install the torque member bolts and the torque member.
Torque member flange bolt:
144.5 N.m (15 kg-m, 107 ft-lb)
- Install the brake pads in the torque member.CAUTION:
- Do not damage the piston boot.
- Do not drop the brake pads, shims, or the shim covers.
- Position the brake caliper to torque member and install the slide pin bolts. Tighten to specification.
- Assemble the union bolt (A) and the copper sealing washers (1) to the brake hose and install it as an assembly to the brake caliper. Align the brake hose L-pin by aligning it with the brake caliper hole, and tighten the union bolt (1) to the specified torque.CAUTION: Do not reuse copper sealing washers.
- Refill with new brake fluid and perform the air bleeding. Refer to Bleeding Brake System .CAUTION:
- Do not reuse drained brake fluid.
- Do not spill or splash brake fluid on the disc brake rotor.
- Install the front wheels and tires. Refer to Adjustment .