Self Diagnostic Results

WARNING: This page is about a different car, the 2018 Nissan Maxima. However, it is still accessible from the selected car via links, so may be relevant.

Display Item List

Refer to DTC Index .

DTC at 1st trip and method to read DTC

DTC is specified by SAE J2012/ISO 15031-6.
DTC and DTC at 1st trip are displayed on "Self Diagnostic results" of CONSULT.
When DTC is currently detected, "CRNT" is displayed. If "PAST" is displayed, it shows a malfunction occurred in the past. The trip number of drive without malfunction of concerned DTC can be confirmed with "IGN counter" inside "FFD".
When the DTC at the 1st trip is detected, "1t" is displayed.

DTC deletion method

NOTE: If the ignition switch is left ON after repair, turn OFF the ignition switch and wait for 10 seconds or more. Then, turn the ignition ON again. (Engine stop)

Touch "TRANSMISSION" of CONSULT.
Touch "Self Diagnostic Result".
Touch "Erase". (DTC memorized in TCM is erased.)

Freeze Frame Data (FFD)

The following vehicle status is recorded when DTC is detected and is displayed on CONSULT.

Item name

Display content

ODOMETER

(km or mile)

Total driving distance (odometer value) upon DTC detection is displayed.

IGN counter

(0-39)

The ignition counter is displayed in "FFD" and the number of times of satisfied "Driving condition A" is displayed after normal recovery of DTC. Refer to Counter System .

Numerical value is displayed indicating the number of times that ignition switch is turned ON after the DTC is detected.

If malfunction (DTC) is currently detected, "0" is displayed.
After normal recovery, every time "Driving condition A" is satisfied, the display value increases from 1 - 2 - 3...38 - 39.
When MIL turns OFF due to the malfunction and the counter reaches 40, the DTC is erased.
NOTE: The counter display of "40" cannot be checked.