Consult Data Monitor Standard Value
- In CONSULT, electric shift timing or lock-up timing, i.e. operation timing of each solenoid valve, is displayed. Therefore, if there is an obvious difference between the shift timing estimated from a shift shock (or engine speed variations) and that shown on the CONSULT, the mechanism parts (including the hydraulic circuit) excluding the solenoids and sensors may be malfunctioning. In this case, check the mechanical parts following the appropriate diagnosis procedure.
- Shift point (gear position) displayed on CONSULT slightly differs from shift pattern described in Service Information. This is due to the following reasons.
- Actual shift pattern may vary slightly within specified tolerances.
- While shift pattern described in Service Information indicates start of each shift, CONSULT shows gear position at end of shift.
- The solenoid display (ON/OFF) on CONSULT is changed at the start of gear shifting. In contrast, the gear position display is changed at the time when gear shifting calculated in the control unit is completed.
|
Monitor item |
Condition |
Value/Status (Approx.) |
|
VSP SENSOR |
While driving |
Almost same as the speedometer display. |
|
ESTM VSP SIG |
While driving |
Almost same as the speedometer display. |
|
INPUT SPEED SENSOR |
In driving (lock-up ON) |
Approximately matches the engine speed. |
|
PRI SPEED SEN |
In driving (lock-up ON) |
Approximately matches the engine speed. |
|
SEC REV SENSOR |
While driving |
VSP SENSOR ± 38 RPM |
|
ENG SPEED SIG |
Engine running |
Almost same reading as tachometer |
|
SEC PRESSURE SEN |
|
1.2 - 1.3 V |
|
PRI PRESSURE SEN |
|
0.9 V |
|
ATF TEMP SEN |
CVT fluid: Approx. 20°C (68°F) |
2.0 - 2.1 V |
|
CVT fluid: Approx. 50°C (122°F) |
1.4 - 1.5 V |
|
|
CVT fluid: Approx. 80°C (176°F) |
0.9 - 1.0 V |
|
|
G SENSOR |
|
0 G |
|
During acceleration |
The value changes to the positive side along with acceleration. |
|
|
During deceleration |
The value changes to the positive side along with deceleration. |
|
|
VIGN SEN |
Ignition switch: ON |
10 - 16 V |
|
PVING VOLT |
Ignition switch: ON |
10 - 16 V |
|
VEHICLE SPEED |
While driving |
Almost same as the speedometer display. |
|
INPUT REV |
In driving (lock-up ON) |
Almost same as the engine speed. |
|
PRI SPEED |
In driving (lock-up ON) |
Approximately matches the engine speed. |
|
SEC SPEED |
While driving |
VSP SENSOR ± 38 RPM |
|
ENG SPEED |
Engine running |
Almost same reading as tachometer |
|
SLIP REV |
While driving |
Engine speed - Input speed |
|
PULLEY GEAR RATIO |
In driving (forward) |
2.4360 - 0.3840 |
|
In driving (reverse) |
2.4360 |
|
|
G SPEED |
Vehicle stopped |
0.00 G |
|
During acceleration |
The value changes to the positive side along with acceleration. |
|
|
During deceleration |
The value changes to the positive side along with deceleration. |
|
|
ACCEL POSI SEN 1 |
Accelerator pedal released |
0.00 deg |
|
Accelerator pedal fully depressed |
80.00 deg |
|
|
VENG TRQ |
While driving |
The value changes along with acceleration/deceleration. |
|
PRI TRQ |
While driving |
The value changes along with acceleration/deceleration. |
|
TRQ RTO |
While driving |
The value changes along with acceleration/deceleration. |
|
SEC PRESSURE |
|
1.1 MPa |
|
PRI PRESSURE |
|
0.7 MPa |
|
FLUID TEMP |
Ignition switch ON. |
Displays the CVT fluid temperature. |
|
DSR REV |
While driving |
It varies along with the driving condition. |
|
TGT PLLY GR RATIO |
In driving (forward) |
2.4360 - 0.3840 |
|
In driving (reverse) |
2.4360 |
|
|
LU PRS |
|
-0.50 MPa |
|
0.65 MPa |
|
|
LINE PRS |
|
1.1 MPa |
|
TRGT PRI PRESSURE |
|
0.7 MPa |
|
TRGT SELECT PRESSURE |
|
0 MPa |
|
0.3 - 0.5 MPa |
|
|
TRGT SEC PRESSURE |
|
1.1 MPa |
|
ISOLT1* |
- |
- |
|
ISOLT2* |
- |
- |
|
PRI SOLENOID* |
- |
- |
|
SEC SOLENOID CURRENT* |
- |
- |
|
SELECT SOLENOID CURRENT* |
- |
- |
|
SOLMON1* |
- |
- |
|
SOLMON2* |
- |
- |
|
PRI SOL MON* |
- |
- |
|
SEC SOL MON CURRENT* |
- |
- |
|
SELECT SOL MON CURRENT* |
- |
- |
|
D POSITION SW |
Selector lever: "D" position |
On |
|
Other than the above |
Off |
|
|
N POSITION SW |
Selector lever: "N" position |
On |
|
Other than the above |
Off |
|
|
R POSITION SW |
Selector lever: "R" position |
On |
|
Other than the above |
Off |
|
|
P POSITION SW |
Selector lever: "P" position |
On |
|
Other than the above |
Off |
|
|
L POSITION SW |
Always |
Off |
|
BRAKESW |
Brake pedal is depressed |
On |
|
Brake pedal is released |
Off |
|
|
IDLE SW |
Accelerator pedal is fully depressed |
On |
|
Accelerator pedal is released |
Off |
|
|
SPORT MODE SW |
Overdrive cotnrol switch: ON |
On |
|
Overdrive control switch: OFF |
Off |
|
|
STRDWNSW |
Paddle shifter (shift-down) is pulled |
On |
|
Other than the above |
Off |
|
|
STRUPSW |
Paddle shifter (shift-up) is pulled |
On |
|
Other than the above |
Off |
|
|
DOWNLVR |
Selector lever: "-" side |
On |
|
Other than the above |
Off |
|
|
UPLVR |
Selector lever: "+" side |
On |
|
Other than the above |
Off |
|
|
NON M MODE |
Driving with manual mode |
Off |
|
Other than the above |
On |
|
|
M MODE |
Driving with manual mode |
On |
|
Other than the above |
Off |
|
|
SHIFT IND SIGNAL |
When the selector lever is positioned in between each position. |
OFF |
|
Selector lever: P position |
P |
|
|
Selector lever: R position |
R |
|
|
Selector lever: N position |
N |
|
|
Selector lever: D position |
D |
|
|
Manual mode: 1st |
1st |
|
|
Manual mode: 2nd |
2nd |
|
|
Manual mode: 3rd |
3rd |
|
|
Manual mode: 4th |
4th |
|
|
Manual mode: 5th |
5th |
|
|
Manual mode: 6th |
6th |
|
|
Manual mode: 7th |
7th |
|
|
CVT LAMP |
Always |
Off |
|
SPORT MODE IND |
Overdrive cotnrol switch: ON |
On |
|
Overdrive control switch: OFF |
Off |
|
|
MANU MODE SIGNAL |
Driving with manual mode |
On |
|
Other than the above |
Off |
|
|
VDC ON |
When VDC malfunction signal is received |
On |
|
Other than the above |
Off |
|
|
TCS ON |
When TCS malfunction signal is received |
On |
|
Other than the above |
Off |
|
|
ABS FAIL SIGNAL |
When ABS malfunction signal is received |
On |
|
Other than the above |
Off |
|
|
ABS ON |
ABS is activated |
On |
|
Other than the above |
Off |
|
|
RANGE |
Selector lever: P and N positions |
N/P |
|
Selector lever: R position |
R |
|
|
Selector lever: D position |
D |
|
|
M GEAR POS |
Manual mode: 1st - 7th |
1 to 7 |
|
G SEN SLOPE |
Flat load |
0% |
|
Uphill gradient |
The value changes to the positive side along with uphill gradient. (Maximum 40.45%) |
|
|
Downhill gradient |
The value changes to the negative side along with downhill gradient. (Minimum 40.45%) |
|
|
G SEN CALIBRATION |
Always |
DONE |
|
N IDLE STATUS |
Always |
Off |
|
ENG BRK LVL |
When the engine brake level of "ENGINE BRAKE ADJ". in "Work Support" is ON |
On |
|
When the engine brake level of "ENGINE BRAKE ADJ". in "Work Support" is OFF |
Off |
|
|
DRIVE MODE STATS |
Drive mode: SPORT |
SPORT |
|
Drive mode: Normal |
NORMAL |
|
|
SNOW MODE |
Always |
Off |
|
ECO MODE |
Always |
Off |
|
NORMAL MODE |
Drive mode: Normal |
On |
|
Drive mode: SPORT |
Off |
|
|
SPORT MODE |
Drive mode: SPORT |
On |
|
Drive mode: Normal |
Off |
|
|
CVT-B* |
- |
- |
|
CVT-A* |
- |
- |
|
AXLE TYPE |
Always |
2WD |
*: These monitor items do not use.