Component Inspection

WARNING: This page is about a different car, the 2018 Nissan NV3500 HD, 2018 Nissan NV2500 HD, and 2018 Nissan NV1500. However, it is still accessible from the selected car via links, so may be relevant.

CHECK CAMSHAFT POSITION (CMP) SENSOR (PHASE)-1

Turn ignition switch OFF.
Loosen the fixing bolt of the sensor.
Disconnect camshaft position (CMP) sensor (PHASE) harness connector.
Remove the sensor.

Visually check the sensor for chipping.

Courtesy of NISSAN NORTH AMERICA, INC.

Is the inspection result normal?

YES

GO TO 2.

Replace CMP sensor (PHASE).

CHECK CMP SENSOR (PHASE)-2

Check the resistance CMP sensor (PHASE) terminals as per the following.

Courtesy of NISSAN NORTH AMERICA, INC.

CMP sensor (PHASE)		Resistance [ Ω at 25°C (77°F)]
+	-
Terminals (Polarity)
1	2	Except 0 or ∞
	3
2	3

Is the inspection result normal?

YES

INSPECTION END

Replace CMP sensor (PHASE). Refer to Removal and Installation .