DTC Confirmation Procedure

WARNING: This page is about a different car, the 2018 Nissan NV3500 HD and 2018 Nissan NV2500 HD. However, it is still accessible from the selected car via links, so may be relevant.

CAUTION: Always drive vehicle at a safe speed.

PRECONDITIONING
If "DTC CONFIRMATION PROCEDURE" is previously conducted, always turn ignition switch OFF and wait at least 10 seconds before performing the next test.

GO TO STEP 2 .

CHECK DTC DETECTION

With CONSULT

Start the engine.
Select "BATTERY VOLT", "MANU MODE SW", "GEAR" and "VHCL/S SE-A/T" in "Data Monitor" in "TRANSMISSION".

Drive vehicle and maintain the following conditions for 5 seconds or more.

BATTERY VOLT	: 9 V or more
MANU MODE SW	: ON
GEAR	: 2nd
VHCL/S SE-A/T	: 10 km/h (7 MPH) or more

Perform "Self Diagnostic Results" in "TRANSMISSION".

With GST

Follow the procedure "With CONSULT".

Is "P2731" detected?

YES

Go to Diagnosis Procedure .

To check malfunction symptom before repair: Refer to Intermittent Incident .

Confirmation after repair: INSPECTION END