DTC Confirmation Procedure

WARNING: This page is about a different car, the 2018 Nissan NV3500 HD and 2018 Nissan NV2500 HD. However, it is still accessible from the selected car via links, so may be relevant.

CAUTION:

" Diagnosis Procedure " must be performed before starting "DTC CONFIRMATION PROCEDURE".
Never perform "DTC CONFIRMATION PROCEDURE" before completing the repair, which may cause secondary malfunction.
Always drive vehicle at a safe speed.

PRECONDITIONING
If "DTC CONFIRMATION PROCEDURE" is previously conducted, always turn ignition switch OFF and wait at least 10 seconds before performing the next test.

GO TO STEP 2 .

CHECK DTC DETECTION

With CONSULT

Start the engine.
Select "SLCT LVR POSI" and "GEAR" in "Data Monitor" in "TRANSMISSION".

Drive vehicle the following condition.

SLCT LVR POSI	: D
GEAR	: 1st through 7th

Perform "Self Diagnostic Results" in "TRANSMISSION".

With GST

Follow the procedure "With CONSULT".

Is "P1730" detected?

YES

Go to Diagnosis Procedure .

To check malfunction symptom before repair: Refer to Intermittent Incident .

Confirmation after repair: INSPECTION END