Active Test Mode

TEST ITEM

CONDITION

JUDGMENT

CHECK ITEM (REMEDY)

FUEL INJECTION

• Engine: Return to the original non-standard condition
• Change the amount of fuel injection using CONSULT.

If malfunctioning symptom disappears, see CHECK ITEM.

• Harness and connectors
• Fuel injector
• Air fuel ratio (A/F) sensor 1

ENG COOLANT TEMP

• Engine: Return to the original non-standard condition
• Change the engine coolant temperature using CONSULT.

If malfunctioning symptom disappears, see CHECK ITEM.

• Harness and connectors
• Engine coolant temperature sensor
• Fuel injector

PURG VOL CONT/V

• Engine: After warming up, run engine at 1, 500 rpm.
• Change the EVAP canister purge volume control solenoid valve opening percent using CONSULT.

Engine speed changes according to the opening percent.

• Harness and connectors
• Solenoid valve

FUEL/T TEMP SEN

• Change the fuel tank temperature using CONSULT.

INT V/T ASSIGN ANGLE

• Engine: Return to the original non-standard condition
• Change intake valve timing using CONSULT.

If malfunctioning symptom disappears, see CHECK ITEM.

• Harness and connectors
• Intake valve timing control solenoid valve

EXH V/T ASSIGN ANGLE

• Engine: Return to the original non-standard condition
• Change exhaust valve timing using CONSULT.

If malfunctioning symptom disappears, see CHECK ITEM.

• Harness and connectors
• Exhaust valve timing control solenoid valve

COOLING FAN*

• Ignition switch: ON
• Turn the cooling fan "HI", "MID", "LOW" and "OFF" using CONSULT.

Cooling fan moves and stops.

• Harness and connectors
• Cooling fan motor
• IPDM E/R

VIAS S/V-1

• Ignition switch: ON
• Turn solenoid valve "ON" and "OFF" using CONSULT and listen to operating sound.

Solenoid valve makes the operating sound.

• Harness and connectors
• Solenoid valve

ENGINE MOUNTING

• Ignition switch: ON
• Turn electronic controlled engine mount "IDLE" and "TRVL" with CONSULT.

Electronic controlled engine mount makes the operating sound.

• Harness and connectors
• Electronic controlled engine mount

VIAS S/V-2

• Ignition switch: ON
• Turn solenoid valve "ON" and "OFF" using CONSULT and listen to operating sound.

Solenoid valve makes the operating sound.

• Harness and connectors
• Solenoid valve

IGNITION TIMING

• Engine: Return to the original non-standard condition
• Timing light: Set
• Retard the ignition timing using CONSULT.

If malfunctioning symptom disappears, see CHECK ITEM.

Perform Idle Air Volume Learning.

POWER BALANCE

• Engine: After warming up, idle the engine.
• A/C switch OFF
• Selector lever: P or N position
• Cut off each injector signal one at a time using CONSULT.

Engine runs rough or stops.

• Harness and connectors
• Compression
• Fuel injector
• Power transistor
• Spark plug
• Ignition coil

VENT CONTROL/V

• Ignition switch: ON (Engine stopped)
• Turn solenoid valve "ON" and "OFF" with the CONSULT and listen to operating sound.

Solenoid valve makes an operating sound.

• Harness and connectors
• Solenoid valve