LEMON Manuals: Even more car manuals for everyone
Home >> Nissan-Datsun >> 2021 >> NV2500 HD S >> Repair and Diagnosis >> External Pages >> Different car >> Section 307 (Engine Control System (DTC/Circuit Diagnosis) (4.0L) (1 Of 4)) >> DTC/Circuit Diagnosis >> DTC P0108: Atmospheric Pressure Sensor >> DTC Confirmation Procedure

DTC Confirmation Procedure

WARNING: This page is about a different car, the 2018 Nissan NV3500 HD, 2018 Nissan NV2500 HD, and 2018 Nissan NV1500. However, it is still accessible from the selected car via links, so may be relevant.
  1. PRECONDITIONING 

    If DTC Confirmation Procedure has been previously conducted, always turn ignition switch OFF and wait at least 10 seconds before conducting the next test.

    YES

    GO TO 2 .

  2. PERFORM DTC CONFIRMATION PROCEDURE 
    1. Start engine and let it idle at least 5 seconds.
    2. Check 1st trip DTC.

    Is 1st trip DTC detected?

    YES

    Proceed to Diagnosis Procedure .

    NO

    To check malfunction symptom before repair: Refer to Intermittent Incident .

    NO

    Confirmation after repair: INSPECTION END

scientia non olet · About LEMON Manuals