LEMON Manuals: Even more car manuals for everyone
Home >> Nissan-Datsun >> 2021 >> NV2500 HD S >> Repair and Diagnosis >> External Pages >> Different car >> Section 307 (Engine Control System (DTC/Circuit Diagnosis) (4.0L) (1 Of 4)) >> DTC/Circuit Diagnosis >> DTC P0107: Atmospheric Pressure Sensor >> Component Inspection

Component Inspection

WARNING: This page is about a different car, the 2018 Nissan NV3500 HD, 2018 Nissan NV2500 HD, and 2018 Nissan NV1500. However, it is still accessible from the selected car via links, so may be relevant.
  1. COMPONENT FUNCTION CHECK 
    1. Turn ignition switch ON.
    2. Check the voltage between ECM harness connector terminals as follows.

      ECM

      Connector

      +

      -

      Terminal

      E16

      107

      112

      NOTE: Since this sensor is an atmospheric pressure sensor, values vary with atmospheric pressure and altitude.
    3. Measure the atmospheric pressure.
      NOTE: As the atmospheric pressure described on the synoptic chart is the value at sea level, compensate the pressure with the following chart.

      Altitude (m)

      Compensated pressure (hPa)

      0

      0

      200

      -24

      400

      -47

      600

      -70

      800

      -92

      1, 000

      -114

      1, 500

      -168

      2, 000

      -218

    4. Check that the voltage is within a specified range as in the following chart.

      Atmospheric pressure (hPa)

      Voltage (V)

      800

      3.1 - 3.7

      850

      3.3 - 3.9

      900

      3.5 - 4.1

      950

      3.8 - 4.3

      1, 000

      4.0 - 4.6

      1, 050

      4.2 - 4.8

      G05733392Courtesy of NISSAN NORTH AMERICA, INC.

    Is the inspection result normal?

    YES

    INSPECTION END

    NO

    Replace atmospheric pressure sensor.