LEMON Manuals: Even more car manuals for everyone
Home >> Nissan-Datsun >> 2021 >> NV2500 HD S >> Repair and Diagnosis >> External Pages >> Different car >> Section 30 (Brake System) >> Unit Disassembly And Assembly >> Rear Disc Brake >> Disassembly and Assembly >> Inspection After Disassembly

Inspection After Disassembly

WARNING: This page is about a different car, the 2018 Nissan Maxima. However, it is still accessible from the selected car via links, so may be relevant.

Brake Caliper Body 

Check inner wall of the brake caliper body for rust, wear, cracks or damage. Replace brake caliper body if any abnormal condition is detected.

CAUTION: Always clean with new brake fluid. Do not clean with mineral oil such as gasoline and light oil.

Torque Member 

Check torque member for rust, wear, cracks or damage. Replace torque member if any abnormal condition is detected.

Piston 

Check surface of piston for rust, wear, cracks or damage. Replace piston if any abnormal condition is detected.

CAUTION: Piston sliding surface is plated. Do not polish with sandpaper.

Slide Pin and Slide Pin Boot 

Check slide pins and slide pin boots for rust, wear, cracks or damage. Replace parts if any abnormal condition is detected.