LEMON Manuals: Even more car manuals for everyone
Home >> Nissan-Datsun >> 2021 >> NV2500 HD S >> Repair and Diagnosis >> External Pages >> Different car >> Section 30 (Brake System) >> Unit Disassembly And Assembly >> Rear Disc Brake >> Disassembly and Assembly >> Assembly

Disassembly and Assembly: Assembly

WARNING: This page is about a different car, the 2018 Nissan Maxima. However, it is still accessible from the selected car via links, so may be relevant.
  1. Install bleeder valve and cap.
  2. Apply rubber grease to piston seal (1), and install it to brake caliper body.
    GNSJPFIA0039Z-039Courtesy of NISSAN NORTH AMERICA, INC.
    CAUTION: Do not reuse piston seal.
  3. Apply rubber grease to piston boot (1). Cover piston (2) end with piston boot, and then install cylinder side lip on piston boot securely into groove on brake caliper body.
    GNSJPFIA0040Z-040Courtesy of NISSAN NORTH AMERICA, INC.
    CAUTION: Do not reuse piston boot.
  4. Apply brake fluid to piston (1). Push piston into brake caliper body by hand and push piston boot (2) piston side lip into piston groove.
    GNSJPFIA0041Z-041Courtesy of NISSAN NORTH AMERICA, INC.
    CAUTION: Press piston evenly and vary pressing points to prevent cylinder inner wall from contact.
  5. Apply Niglube Rx-2 grease to bushing; install bushing to slide pin.
  6. Apply Niglube Rx-2 grease to slide pin boots and slide pins.
  7. Install slide pin boots and slide pins to torque member.
  8. Install the brake caliper to vehicle. Refer to Removal and Installation .
scientia non olet · About LEMON Manuals