LEMON Manuals: Even more car manuals for everyone
Home >> Nissan-Datsun >> 2021 >> NV2500 HD S >> Repair and Diagnosis >> External Pages >> Different car >> Section 30 (Brake System) >> Unit Disassembly And Assembly >> Front Disc Brake >> Disassembly and Assembly >> Disassembly

Disassembly and Assembly: Disassembly

WARNING: This page is about a different car, the 2018 Nissan Maxima. However, it is still accessible from the selected car via links, so may be relevant.
  1. Remove brake caliper from vehicle. Refer to Removal and Installation .
  2. Remove slide pin boots from torque member.
  3. Remove slide pin bushing from slide pin.
  4. Place a wooden block in cylinder body and blow air from union bolt hole to remove piston and piston boot.
    G04076658Courtesy of NISSAN NORTH AMERICA, INC.
    WARNING: Do not get fingers caught between pistons and brake caliper body.
    CAUTION: Do not reuse piston boot.
  5. Remove piston seal from brake caliper body using a suitable tool.
    GNSJPFIA0038Z-038Courtesy of NISSAN NORTH AMERICA, INC.
    CAUTION:
    • Do not damage cylinder inner wall.
    • Do not reuse piston seal.
  6. Remove bleeder valve and cap.
scientia non olet · About LEMON Manuals