LEMON Manuals: Even more car manuals for everyone
Home >> Nissan-Datsun >> 2021 >> NV2500 HD S >> Repair and Diagnosis >> External Pages >> Different car >> Section 30 (Brake System) >> Removal And Installation >> Rear Disc Brake >> Brake Caliper Assembly >> Removal and Installation >> Removal

Removal and Installation: Removal

WARNING: This page is about a different car, the 2018 Nissan Maxima. However, it is still accessible from the selected car via links, so may be relevant.
  1. Observe brake fluid level in reservoir tank. Partially drain brake fluid if necessary. Refer to Drain and Refill .
  2. Remove rear wheels and tires using a power tool. Refer to Removal and Installation .
  3. Remove union bolt and then remove brake hose from brake caliper. Discard copper sealing washers.
    CAUTION: Do not reuse copper sealing washers.
  4. Remove slide pin bolts.
    NOTE: Note slide pin orientation during removal. The upper slide pin contains a bushing.
  5. Remove brake caliper from torque member.
  6. Remove brake pads and shims from torque member.
  7. Remove torque member bolts and torque member.
scientia non olet · About LEMON Manuals