Stop Lamp Switch And Brake Pedal Position Switch
WARNING: This page is about a different car, the 2018 Nissan Maxima. However, it is still accessible from the selected car via links, so may be relevant.
- Remove instrument lower panel LH. Refer to Removal and Installation .
- Disconnect the harness connectors from the stop lamp switch and brake pedal position switch.
- Turn the stop lamp switch and brake pedal position switch 45° counterclockwise.
- With threaded ends of stop lamp switch (1) and brake pedal position switch (2) contacting pedal bracket (3), turn switches 45° clockwise to lock in place. Check that both stop lamp switch and brake pedal position switch contact ends to brake pedal bracket clearance (A) are within specification.CAUTION:
- Make sure that the clearance between the brake pedal bracket, stop lamp switch and the brake pedal position switch contact ends are within specification.
- The stop lamp must turn off when the brake pedal is released.
Clearance (A)
: Refer to Brake Pedal .
- Connect harness connectors to stop lamp switch and brake pedal position switch.
- Install instrument lower panel LH. Refer to Removal and Installation .