Removal and Installation: Installation

WARNING: This page is about a different car, the 2018 Nissan Maxima. However, it is still accessible from the selected car via links, so may be relevant.

Installation is in the reverse order of removal.

Place a washer (A) as shown to install wheel studs (1) by using tightening force of nut (B).

Courtesy of NISSAN NORTH AMERICA, INC.
CAUTION:
- Check that there is no clearance between wheel stud and wheel hub and bearing.
- Do not reuse wheel stud.
Make sure wheel hub and bearing operate smoothly.
Install rear wheel sensor to rear knuckle. Refer to Exploded View .
CAUTION:
- Before installing, make sure there is no foreign material, such as iron fragments, on pick-up part of rear wheel sensor.
- When installing, make sure there is no foreign material, such as iron fragments, on and in the hole in rear knuckle for rear wheel sensor. Make sure no foreign material has been caught in sensor rotor. Remove any foreign material and clean mount.