Removal and Installation: Installation

WARNING: This page is about a different car, the 2018 Nissan NV3500 HD and 2018 Nissan NV2500 HD. However, it is still accessible from the selected car via links, so may be relevant.

Installation is in the reverse order of removal.

If the propeller shaft or final drive has been replaced, connect them as follows:

Courtesy of NISSAN NORTH AMERICA, INC.
- Install the propeller shaft while aligning its matching mark (A) with the matching mark (B) on the joint as close as possible.
- Tighten the propeller shaft to final drive bolts the specified torque.
  CAUTION: Do not reuse the bolts and nuts. Always install new ones.
After installation, check for vibration by driving the vehicle. Refer to NVH Troubleshooting Chart .